As my kids want their own rooms in the future I’ll need to downsize a bit. Is there a list for recommended 10” Equipment? Any help appreciated. My research so far turned always in the direction of get rack bars and a 3D printer ( or shops selling the 3d prints)
You must log in or register to comment.
Reddit == Evil, but if you’re looking for ideas there’s an entire subreddit dedicated to this. Tons of ideas, links to 3d prints, and more:
Are pi’s or other single board computers options for you? My home lab runs on a handful of pi’s a dying mac mini (I am looking at replacing the thing with a better computer) and a Flint 2, running OpenWRT. I have a Rock 5 or something like that but have never been able to figure it out.
I’m currently running on a pi4 and a HP Elitedesk, those should be fine. Just need to tidy up everything else because I have to target a higher wife acceptance factor
It’s a bit hard to justify a 3d printer for a single project, but if you think you’ll use it for other projects then that’s the way I would go. I just finished putting together a bit of a Frankenstein 10" rack based around these https://www.printables.com/model/1564648-rail-with-integrated-caps-for-10-inch-rack-system https://www.printables.com/model/1173672-10-mini-rack-all-3d-printable
Biggest callout would be to make sure the printers you’re looking at have a large enough bed size to print the model you land on. The original one I was planning on printing couldn’t fit on my printer.